Aspect - Canon WX6000 User Commands

ASPECT

Screen settings
Format
ASPECT=<Screen setting parameters: ID>
GET□ASPECT / ?△ASPECT
<Screen setting parameters:ID>
AUTO
4:3
16:9
16:10
ZOOM
TRUE
Environment
Power
OFF ON PM Parameter
X O X AUTO
4:3
16:9
16:10
ZOOM
TRUE
*1 Enabled when "HDMI input" setting is PC or "HDMI input" is auto and the
input signal is PC system.
*2 Depend on Input setting. Enabled when "HDMI input" setting is PC.
*3 Enabled when "HDMI input" is auto and the input signal is video system.
*4 Depend on Input setting.Enabled when "HDMI input" setting is auto.
*5 Enabled when the input signal resolution is smaller than the screen aspect
domain resolution.
Response
"i:OK" is returned if the parameter was set properly.
For ' ' or '
GET ASPECT ?ASPECT
'g:ASPECT=<Screen setting parameters:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This sets the screen sizes.
(2) This command functions in the same way as when "Display settings" - "Aspect" are selected on
the menu.
(3) If the command cannot be supported, 'INVALID_SOURCE' is returned as an error response.
(4) If the necessary signals are not input, 'NO_SIGNAL' is returned.
(5) The final screen settings are retained even when the power is turned off. However, the screen
settings may be different if the input terminal or input signal is changed.
(6) The GET command can be used to retrieve the current screen display mode. ("
Auto
4:3
16:9
16:10
Zoom
Real
Input
D-RGB A-RGB COMP
○ ○ ○
○ ○ ○
○ ○ ○
○ ○ ×
× × ○
*5 *5 *5
', current screen display mode is returned as
- 24 -
WX6000 / SX6000 User Commands
HDMI None
○ ○
○ ○
○ ○
*1 *2
*3 *4
○
*5
")
GET ASPECT