Position; H Size; Aspect - Canon LV-WU360 User Manual

Display
V Position
(Only for PC signal input)
On the premise that the relative position of both pro-
jector and the screen is set up right,you can move the
image vertical position,if the position of the projected
image on the screen is deviated.
1) Press button to select [V Position] menu.
2) Press <OK> button.
3) Press button to adjust image V position.
Adjustment range is from -5 to +5.

H size

(Only for PC signal input)
You can adjust and reduce the interference caused
by patterns of the projected vertical stripes.The
following projected patterns may cause a circular
pattern (Noise). Adjust the amount of interference
to the minimum. Users can point the clock to adjust
images.
1) Press button to select [H size] menu.
2) Press <OK> button.
3) Press button to adjust H size level .
Adjustment range is from -15 to +15.

Aspect

Adjust the image to fit the screen size,while keeping
aspect of input signal's unchanged.
Press < MENU > button on the remote controller or
on the top control panel to display the OSD menu.
Press button to select the Display menu ,then
Press <OK> or button.
1) Press button to select [ Aspect ] menu.
2) press <OK> button.
3) Press button to select the required item.
Auto....Use the maximum size to project while
keeping the aspect of input signal's
unchanged.
16:9...Project images to aspect ratio 16:9.
Full...........Project images to the maximum.
Only for PC (VGA) signal input .
●
Advanced ...... Splicing screen.
Only for PC (VGA) signal input .
●
Aspect menu
Display
Auto PC adj.
Fine sync
H position
V position
H.Size
Aspect
Image Flip H/V
Menu position
Background display
Signal Format
51
0
0
0
0
Auto
None
Upper left
Blue
----