APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual page 93

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO FACTORY ABS
•
Small black clamps 98 x 2.5 (3.86 x 0.01 in)
•
1 10-cm (3.94 in) spiral for start-up cable
•
1 Pick-Up divider cable harness (if fitted)
Motorcycle division
The wiring distribution is subdivided in three es-
sential sections, as indicated in the figure.
1. Front section
2. Central section
3. Rear section
Special checks for the correct connection and laying of cables
Carry out the checks described below once the electrical system is refitted, connectors recon-
nected and clamps and retainers restored.
•
Check the connector block for connections and correct tightening in the following connec-
tors.
1. Instrument panel connector: FRONT SECTION.
2. Handgrip sensor connectors: CENTRAL SECTION, TABLE G
3. Pick Up Connector: CENTRAL SECTION.
4. Side Stand Switch Connector: CENTRAL SECTION, TABLE C.
5. Regulator Connector: CENTRAL SECTION, TABLE O.
6. Front cylinder coil and rear cylinder coil connectors.
7. Filter Housing Connectors.
8. ECU and Ground Lead Connectors for the filter casing: CENTRAL SECTION, TABLE C.
9. Fuel Pump Connector.
10.Key Connector - Right Light Switch Connectors - Left Light Switch Connectors: Connectors inside
the housing behind the radiator: FRONT SECTION, TABLE B.
•
THE CONNECTORS LISTED ARE CONSIDERED CRITICAL IN COMPARISON WITH
ANY OTHER BECAUSE THE VEHICLE WILL STOP IF THEY ARE ACCIDENTALLY DIS-
CONNECTED.
•
Undoubtedly the connection of the rest of connectors is also important and essential for the
correct operation of the vehicle.
Front side
CAUTION
ONCE THE ELECTRICAL SYSTEM IS REFITTED, THE CONNECTORS RECONNECTED AND
CLAMPS AND RETAINERS RESTORED, CARRY OUT THE CHECKS INDICATED UNDER "SPE-
CIAL CHECKS FOR THE CORRECT CONNECTION AND LAYING OF CABLES" IN THE "ELEC-
TRICAL SYSTEM INSTALLATION" SECTION.
email: info@motomatrix.co.uk
Electrical system
ELE SYS - 93