APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual page 158

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
Electrical system
•
Indication on Navigator always released: check the correct position of the cable terminals
on the connector and the correct connection of the cables on the terminals. If they are not
correct, restore the cable harness; if correct, disconnect the two terminals from the sensor
and, with key set to ON, check continuity to ground connection of PIN 2: if there is no con-
tinuity, restore the cable harness; if there is, replace the sensor
•
Indication on Navigator always pulled: disconnect the terminals from the sensor and check
if there is continuity between the two PINS, with clutch released: if there is continuity, replace
the sensor. If the circuit is open, it means that the brown/purple cable from sensor PIN 1 to
ENGINE connector PIN 50 is shorted to ground: restore the cable harness
Side stand sensor
SIDE STAND SENSOR
Function
It tells the side stand position to the control unit.
Operation / Operating principle
If the gear is engaged and the side stand is unfol-
ded, and therefore the circuit is open, the control
unit does not enable vehicle start-up or shuts off
the engine if it is rotating.
Level in electrical circuit diagram:Start-up ena-
bling switches
Location:
•
on the vehicle: on the side stand
•
connector: left side, near the Marelli
control unit
Electrical characteristics:
•
Side Stand Up: closed circuit (continu-
ity)
•
Side Stand Down: open circuit (infinite
resistance)
Pin-out:
1. Ground connection
2. Voltage 12V
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
NAVIGATOR: STATUSES
ELE SYS - 158
email: info@motomatrix.co.uk
DORSODURO FACTORY ABS