APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual page 57

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
DORSODURO FACTORY ABS
WHEN REFITTING, ALSO ENSURE THAT THE SEMI-BUSHINGS ARE ALL OF THE SAME CLASS.
See also
Removing the flywheel cover
Selecting bushings
There is only one dimension class for the connecting rod. As a result, the bushings used must be
selected in accordance with the dimension class of the crank pin.
Crank pin diameter
Crankshaft class 0
Crankshaft class 1
Crankshaft class 2
Crankshaft class 3
Selecting connecting rods
Not all weight classes are available as spare parts. Only the two most significant weight classes are
available - refer to the following table for selection:
Class according to crankshaft weight
E1
E2
E3
E4
E5
E6
E7
CAUTION
THE CONNECTING RODS INSTALLED ON THE SAME ENGINE MUST BE OF THE SAME COLOUR
AND MUST USE THE SAME TYPE OF ASSEMBLY WITH THE CRANKSHAFT.
WHEN REFITTING, ALSO ENSURE THAT THE SEMI-BUSHINGS ARE ALL OF THE SAME CLASS.
See also
Removing the flywheel cover
Recommended products chart
Product
AGIP TEC 4T, SAE 15W-50
FUCHS TITAN SAF 1091
AGIP MP GREASE
AGIP CHAIN GREASE SPRAY
AGIP BRAKE 4 / BRAKE 5.1
AGIP BRAKE 4 / BRAKE 5.1
email: info@motomatrix.co.uk
BUSHINGS
CONNECTING RODS
R
ECOMMENDED PRODUCTS
Description
Engine oil
Fork oil
Grease for bearings, joints, couplings
and leverages
Recommended CHAIN oil
Recommended BRAKE FLUID
Recommended CLUTCH FLUID
Characteristics
Connecting rod class 1
Semi-bushing type E (green)
Semi-bushing type A (red)
Semi-bushing type B (blue)
Semi-bushing type C (yellow)
Original connecting rod class
Brown connecting rod
Blue connecting rod
Yellow connecting rod
Green connecting rod
Pink connecting rod
Black connecting rod
White connecting rod
Specifications
Use top-brand oils that meet or exceed
the requirements of API SJ/CCMC G4/
ACEA A3-04/ JASO MA specifications.
-
As an alternative to the recommended
product, use top brand grease for roller
bearings with an operating temperature
range of -30°C...+140°C (-22°F...+284°
F), a drop point of 150°C...230°C (302°
F...446°F), high corrosion protection
qualities and good water and rust resist-
ance.
Grease
-
-
CHAR - 57