APRILIA DORSODURO FACTORY ABS 2011 Service Station Manual page 162

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
Electrical system
RUN/STOP switch
Run / stop switch
Function
It tells the control unit if the driver wishes to enable
engine start-up or to keep the engine running.
Operation / Operating principle
If the driver wants to shut off the engine or to dis-
able engine start-up, the switch should be open,
i.e. the Marelli control unit should not detect volt-
age at VEHICLE connector PIN 26.
Level in electrical circuit diagram:Start-up ena-
bling switches.
Location:
•
on the vehicle: right light switch
•
connector: fixed to the "L" support
bracket placed over the clutch housing.
Electrical characteristics:
•
STOP position: the circuit is open
•
RUN position: closed circuit (continui-
ty)
Pin-out:
1. Yellow/grey cable: -
2. Red/black cable: Voltage 12V
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
NAVIGATOR: PARAMETERS
-
NAVIGATOR: STATUSES
Run / stop switch
Example value:Run/Stop
Indication on Navigator always STOP: disconnect the connector and, with the switch set to RUN, check
if there is continuity toward the switch of the two yellow/grey and red/black cables: if there is no con-
tinuity, replace the sensor; if there is, check the connector. If not OK, restore the cable harness; if it is
OK, with key set to ON, check if there is voltage to the red/black cable: if there is no voltage, restore
the cable harness; if there is, check the yellow/grey cable ground insulation: if there is continuity to
ground, restore the cable harness; if it is correct, take the key to OFF and check the VEHICLE connector
ELE SYS - 162
email: info@motomatrix.co.uk
DORSODURO FACTORY ABS