Installing The Air Lines - Air Lift LoadLifter 5000 Ultimate Installation Manual

8 . Left-side shown with the assembly bolted up to the frame bracket (fig. 29).

INSTALLING THE AIR LINES

1 . On the passenger side only, place the provided thermal sleeve (HH) on the air line near
2 . Remove the air line heat shield sleeve in the hose heat shield kit and install on the right
3 . Choose a convenient location for mounting the inflation valves. Popular locations for the
NOTE What ever the chosen location is, make sure there is enough clearance around the inflation
valves for an air chuck.
4. Drill a 5/16" hole to install the inflation valves.
5 . Cut the air line assembly (AA) in two equal lengths .
WHEN CUTTING OR TRIMMING THE AIR LINE, USE A HOSE CUTTER, A RAZOR BLADE
CAUTION
OR A SHARP KNIFE . A CLEAN, SQUARE CUT WILL ENSURE THAT THE LINE WILL NOT
LEAK . DO NOT USE WIRE CUTTERS OR SCISSORS TO CUT THE AIR LINE . THESE
TOOLS MAY FLATTEN OR CRIMP THE AIR LINE, CAUSING IT TO LEAK AROUND THE
O-RING SEAL INSIDE THE ELBOW FITTING (FIG . 31)
14
the exhaust .
side (passenger side) air line where it attaches to the fitting on the upper bracket (fig. 30).
inflation valve are:
a. The wheel well flanges.
b . License plate recess in bumper .
c . Under the gas cap access door .
d . Through license plate itself .
LoadLifter 5000 Ultimate
fig. 29
Insert the
air line into
the heat
shield before
attaching to
the right-side
(passenger)
air spring
fitting.
fig. 30
MN-944