Rating, Approval, And Tag Plates; Configuration - Siemens 7MF4033 series User Manual

UMSITRPDS3-1

1.3 RATING, APPROVAL, AND TAG PLATES

These plates are fastened to the outside of the transmitter
enclosure, as shown at right. The rating plate shows that
transmitter's model number, serial number, and performance
data. The approval plate shows that transmitter's approval and
certification data. Always refer to these plates to confirm the
model number, performance data and approval and certification
data before installing or servicing a transmitter. Representative
plates are shown below.
The tag plate is fastened with two screws so it can be
removed for engraving.
SIEMENS
D-76181 Karlsruhe
SITRANS P
Transmitter for diff. pressure
7MF4433-1DA20-1HC6-Z
A01+B11+Y01
Feb. Nr. N1-M831-9292402
VH :DC 10.5-45V (not intr. safe) outp.: 4-20 mA
Mat.: Connec. Diaphr. O-ring Filling
1.4408 1.4404
Measuring span
Rated pressure
Type of protection IP 65
Made in USA
Rating Plate
1 Model number
2 Serial number

1.4 CONFIGURATION

A transmitter must be configured before use. Each transmitter is shipped with either a default
configuration or, if specified at time of order, a custom configuration defined by the user. The default
configuration may need to be edited before the transmitter is used in a loop. The configuration is stored
within the transmitter in a non-volatile memory.
A configuration can be created or edited locally at the transmitter's magnetic pushbuttons or remotely
using the Model 275 HART Communicator.
Note: If using a Model 375 Field Communicator, see the inside of the front
cover of this manual.
November 2005
1
2
FPM Siliconoil
: 2.5 - 250 mbar
: PN 160
+
1
1 Rating plate
2 Approval plate
3 Tag plate
SIEMENS
D-76181 Karlsruhe
SITRANS P
(XP/DIP) or (IS)
CL I ZN 0/1 AEX ia IIC T4..T6
CL I,II,II DIV 1 ABCKEFB T4..T6
APPROVED
Per Control Dwg. A5E00072770A
Vi < 30V : Ii < 100 mA : Pi < 0.75 W
Ci < 6 nF : Li < 0.4 mH
(NI) CL 1 DIV 2 ABCD T4..T6
CL II DIV 2 GP FB, CL III
Vmax = 30 V
Ta - T4: -40..85ºC ; T6: -40..60ºC
ENCL Type 4X
FW: 11.02.03 HW: 02.05.01
Approval Plate
Introduction
+
2
3
FM
1-9