Cisco 200 Series Administration Manual page 33

Managing System Files
Upgrade/Backup Firmware/Language
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
A single firmware image is stored on the switch. After uploading a new firmware
image to the switch, that image is used. After new firmware has been successfully
loaded into the switch, the device needs to be rebooted prior to the new firmware
taking effect. The Summary page will continue to show the previous image prior to
the reboot.
To download or backup a system or language file:
Click Administration > File Management > Upgrade/Backup Firmware/
Language. The Upgrade/Backup Firmware/Language page opens.
Click the Transfer Method. If you selected TFTP, go to
HTTP, go to STEP 4.
If you selected TFTP, enter the parameters as described in this step. Otherwise,
skip to STEP 4.
Select the Save Action.
If for the Save Action you select Upgrade to specify that the file type on the
switch is to be replaced with a new version of that file type located on a TFTP
server, do the following. Otherwise, go to the next procedure in this step.
a. File Type—Select the destination file type. Only valid file types are shown.
(The file types are described in the
b. Server Definition—Select whether to specify the TFTP server by IP address
or domain name.
c. IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
• Link Local—The IPv6 address uniquely identifies hosts on a single network
link. A link local address has a prefix of FE80, is not routable, and can be used
for communication only on the local network. Only one link local address is
supported. If a link local address exists on the interface, this entry replaces
the address in the configuration.
• Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
d. Link Local Interface—Select the link local interface (if IPv6 is used) from the
list.
e. TFTP Server IP Address/Name—Enter the IP address or the domain name of
the TFTP server.
f. Source File Name—Enter the name of the source file.
STEP
Files and File Types
4
3. If you selected
section.)
33