Cisco 200 Series Administration Manual page 158

Configuring IP Information
Management and IP Interfaces
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide
To define a default router:
Click Administration > Management Interface > IPv6 Default Router List.
The IPv6 Default Router List Page opens.
This page displays the following fields for each default router:
• Default Router IPv6 Address—Link local IP address of the default router.
• Interface—Outgoing IPv6 interface where the default router resides.
• Type—The default router configuration that includes the following options:
- Static—The default router was manually added to this table through the
Add button.
- Dynamic—The default router was dynamically configured.
State—The default router status options are:
- Incomplete—Address resolution is in process. Default router has not yet
responded.
- Reachable—Positive confirmation was received within the
Time.
- Stale—Previously-known neighboring network is unreachable, and no
action is taken to verify its reachability until it is necessary to send traffic.
- Delay—Previously-known neighboring network is unreachable. The
switch is in Delay state for a predefined
received, the state changes to Probe.
- Probe—Neighboring network is unavailable, and Unicast Neighbor
Solicitation probes are being sent to verify the status.
Click Add to add a static default router. The Add Default Router Page opens.
The window displays the Link Local Interface. The interface can be a port, LAG,
VLAN, or tunnel.
Enter the static default router IP address in the Default Router IPv6 Address field.
Click Apply. The default router is defined, and the switch is updated.
Reachable
Delay Time.
If no confirmation is
15
158