Cisco 200 Series Administration Manual page 177

Configuring Security
Defining Access Profiles
STEP 3
STEP 4
STEP 5
Cisco Small Business 200 Series Smart Switch Administration Guide
A caution message displays if you selected any other access profile, warning you
that, depending on the selected access profile, you might be disconnected from
the web-based switch configuration utility.
Some 200 Series switches only support web access (http only, not
NOTE
https). The profile you define may be customized according to a set of
settings provided in Access Profile entry, but ultimately will only provide
web access; console or any other methods (HTTPS, SSH & Telnet) are not
supported.
Click OK to select the active access profile or click Cancel to discontinue the
action.
Click Add to open the Add Access Profile Page. The page allows you to configure
a new profile and one rule. Go to the
instructions on how to construct a rule.
Enter the parameters.
• Access Profile Name—Enter an access profile name. The access profile
name can contain up to 32 characters.
• Rule Priority—Enter the rule priority. When the packet is matched to a rule,
user groups are either granted or denied access to the switch. The rule
priority is essential to matching packets to rules, as packets are matched on
a first-match basis. One is the highest priority.
• Management Method— HTTP management is available.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the switch if the user matches the settings in
the profile.
- Deny—Denies access to the switch if the user matches the settings in the
profile.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies only to the port, or LAG selected.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. The Source IP Address field is valid for a
subnetwork. Select one of the following values:
- All—Applies to all types of IP addresses.
Defining Profile Rules
16
section for
177