Figure 18 Controller (Eternus Dx600 S3) - Fujitsu ETERNUS DX500 S4 Operation Manual

1. Component Names and LED Names
Controller Enclosures
●
Controller (ETERNUS DX600 S3)
Figure 18 shows the controller of the ETERNUS DX600 S3.

Figure 18 Controller (ETERNUS DX600 S3)

3
1
5 6
1. Host interface (CA#0)
Install host interfaces. For details, refer to
2. Host interface (CA#1)
Install host interfaces. For details, refer to
3. Host interface (CA#2)
Install host interfaces. For details, refer to
4. Host interface (CA#3)
Install host interfaces. For details, refer to
5. FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
6. RMT (LAN) port
This port is used for connecting a LAN cable and used for the remote support function. This port uses an RJ-45
connector.
7. MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45 con-
nector.
8. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between enclo-
sures.
9. PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems Operation Guide (Basic)
7
"■ Host Interfaces" (page
"■ Host Interfaces" (page
"■ Host Interfaces" (page
"■ Host Interfaces" (page
Copyright 2018 FUJITSU LIMITED
8 9
26).
26).
26).
26).
24
4
2
P3AM-7742-12ENZ0