Connecting The Power Supply - Omron CS1W-ETN01 Operation Manuals

Connecting to the Network

3-6-4 Connecting the Power Supply

4. Connect the transceiver cable to the Ethernet Unit connector. The Ethernet
Unit connector has a slide latch conforming to IEEE802.3 specifications that
serves as a lock mechanism. To connect the transceiver cable, operate the
slide latch as described below.
a) First push the slide latch upwards.
b) Insert the cable connector into the Ethernet Unit's connector with the two
locking posts at the end of the cable connector aligned with the holes in
the slide latch.
c) Then push the slide latch down to lock the cable connector in place.
Slide latch
Lock post
Connect a 24-VDC power supply to the power supply terminals. The Ethernet
Unit converts this 24-VDC power supply to the power supply voltage for the
transceivers and provides it through the transceiver cable.
24-VDC input
Crimp terminals must be used for the power supply cable. The applicable M3
crimp terminals and recommended products are shown below.
6.2 mm max.
Maker Model
J.S.T.MFG.CO.,
V1.25-N3A
LTD
V1.25-MS3
MOLEX JAPAN VSY1.25-3.5L
CO.,LTD
RAV1.25-M3
Lock post
24-VDC power supply
6.2 mm max.
Specifications Applicable power line
range (stranded wire)
0.25 to 1.65 mm
Fork terminal with
(AWG: #22 to #16)
vinyl insulation
Ring terminal with
vinyl insulation
Fork terminal with 0.3 to 1.65 mm
vinyl insulation (AWG: #22 to #16)
Ring terminal with
vinyl insulation
Section 3-6
2
2
29