Installation And Start-Up Procedure - illy X1 Instructions Manual

1 - INSTALLATION AND START-UP PROCEDURE

Note: At fi rst start-up and in case of several days of inactivity, it is recommended to dispense at least half a tank of water without capsules in the machine, placing a suitable
container under the dispensing spout.
1
Remove the water tank. Fill with fresh drinking
water up to the MAX level.
5
The light starts blinking purple for fi fteen seconds,
then blue: warm-up phase.
2
Insert the water tank completely into the machine.
6
When the light is steady on, an acoustic signal
indicates that the machine is ready.
3
Insert the power cord into the socket.
After 10 minutes of inactivity, the machine automatically enters the Power Save mode.
The light (A) (Fig. 5) starts blinking. Press any button to turn on the machine again.
4
Switch the power button to "I" to turn on the
machine. The light (A) turns on.
EN
7