Programming; Front Panel Description; Access Codes - Teletek electronics SIMPO Basic Information

2.) Programming

2.1) Front Panel Description

2.1.1) Access codes

To access the Programming and Maintenance Menus it is necessary to enter a
valid access code. There are 3 access codes programmed by default:
- USER Access – no code needed
- Maintenance Access code
- Installer Access code
Access code length is maximum 4 digits.
Introducing the codes is by means of the special number buttons on the front panel:
Code type
User
Maintenance
Installer
The entered code combination is confirmed by pressing the Enter button. You can
delete the entered digits by pressing the Enter button again. Exit from the access level is by
pressing the Esc button.
Page 6 of 48
Simpo Addressable Panel
SIMPO - BASIC INFORMATION
Access codes table
Code combination
-
2222
3333
Access
level
Only Silence Buzzer and
Evacuation (If there is a fire
alarm active – it will be for
removing of the active delays
of Sirens output, Fire Output,
1
Addressable Sounders and
MOUT modules) buttons are
active. It is not allowed to enter
the Programming and
Maintenance Menus.
Silence Buzzer, Silence Alarm,
Reset and Evacuate buttons
are active. It is allowed to
2 enter only the Maintenance
Menus. Also the extinguishing
module buttons for disabling
are active.
Silence Buzzer, Silence Alarm,
Reset and Evacuate buttons
are active. It is allowed to
3 enter both the Programming
and Maintenance Menus. Also
the extinguishing module
buttons are active.
Functions