Powering Up The M3 Sonar Phs For The First Time - Kongsberg M3 Sonar Installation Manual

M3 Sonar PHS Installation Manual
Note
The Sonar Processor, breakout box, and power supply are designed for indoor use and
should be installed at the operator station (wheelhouse).
7 Make sure that the required software packages have been installed on your Sonar
Processor, including the Seapath Operator Software, M3 software, and third-party
acquisition software.
Further requirements
You are now ready to power up the M3 Sonar PHS for the first time.
Powering up the M3 Sonar PHS for the first
time
Power up the M3 Sonar PHS using the power switch on the M3 Sonar Interface Unit.
Prerequisites
• The M3 Sonar PHS units have all been installed according to the instructions provided in
the M3 Sonar PHS Installation Manual.
• All power and interface cables and connections have been connected and verified.
• All system units have been inspected.
Caution
Do not power up the system if the Z-pole is oriented horizontally with the main system
units out of the water.
Context
The M3 Sonar Interface Unit provides power to the following units.
• Seapath 130 sensor and Motion Reference Unit (MRU)
• M3 Sonar Head
• Sound speed sensor
The Sonar Processor has its own power adapter.
50
922-00037011/1.0