M3 Sonar PHS
Installation requirements
Topics
Supply power requirements, page 17
Uninterruptible Power Supply (UPS) requirements, page 17
Supply power requirements
Observe the general requirements related to the supply power.
The supply voltage to the equipment must kept within ±10% of the installation's nominal
voltage. Maximum transient voltage variations on the main switchboard's bus-bars are not
to exceed -15% to +20% of the nominal voltage (except under fault conditions).
Uninterruptible Power Supply (UPS) requirements
Observe these requirements related to the Uninterruptible Power Supply (UPS).
The Uninterruptible Power Supply (UPS) must have the capacity to independently maintain
power to the M3 Sonar PHS for a minimum of 10 minutes.
This ensures that the M3 Sonar PHS can be turned off in a controlled manner in the event
of a power failure.
Support information
If you need technical support for your M3 Sonar PHS you must contact your local dealer, or
our support department.
If you require maintenance or repair, contact your local dealer. You can contact us by phone
at +1 604 464 8144, or by email at: km.support.vancouver@km.kongsberg.com. If you need
information about our other products, visit http://www.km.kongsberg.com/mesotech. On
our website you will also find a list of our dealers and distributors.
17
922-00037011/1.0