BandLuxe R560 Series User Manual page 44

Network
Mode:
PIN Code:
Start:
42
Specifies the WPS setup mode
PBC Mode - Push Button Configuration mode
(Note: To use this setup method, the client
must have a WPS button configured to PBC
Mode too.)
PIN Mode - Personal Identification Number mode
(Note: To use this setup method, the client
must have a WPS button configured to PBC
Mode too.) After choosing PIN Mode, an
additional text box item "PIN Code" will appear.
This text box item appears when 'Mode' is set to "PIN Mode".
Enter the 8-digit alphanumeric PIN in the text box. This PIN must
match the PIN of the router client.
If the PIN entered is invalid, the text color will become red with
an on the right side.
Whenever the PIN entered is valid, the text color will be black.
After setting up WPS Mode (PBC or PIN), click the router client's
corresponding hardware/software WPS button (actual router
client hardware/software WPS button behavior will depend on
router client's manufacturer design).
Click on or press-and-hold the router's physical Signal
Strength LED/WPS/Reset button for around 3 seconds to start
the WPS process.