Dsl Sfp Module - Cisco IR1101 User Manual

DSL SFP Module

Table 13: Supported FE SFPs
FE SFP Distance
GLC-FE-100FX-RGD 2 km
GLC-FE-100LX-RGD 10 km
For the most up-to-date list of supported SFP models for Cisco Industrial Ethernet switches, see
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html#wp138176
DSL SFP Module
This section provides an example of installing and removing the DSL SFP module.
Attention Prior to installing the DSL SFP Module, please note the following statements:
1. Follow all of warning notices and instructions marked on the product or in the user manual.
2. Do not install telephone wiring during a lightning storm.
3. The device should be installed by a service/skilled person on stationary pluggable equipment and connected
to a socked-outlet with a protective earthing conductor to building earth.
4. External paired conductor cable should be minimum wire diameter of 0.4 mm, shall have the current
limited to 1.3 A.
5. Please disconnect RJ45/RJ11 line before disconnect the power supply.
The following photo shows the DSL SFP Module:
Note
SFP-VADSL2+-I was evaluated to country specific regulatory requirements only. The product was not
evaluated to IEC 61850-3 and IEEE1613 substation / utility standards.
Product Overview
20
Fiber Commercial Extended
0C ~ +70C -5C ~
+85C
MMF
SMF
Industrial DOM
-40C ~
+85C
YES
YES
Product Overview