Lab.gruppen PLM 20K44 Operation Manual page 56

7. Front Panel Interface
7.11.5.1. Frame Info
MENU > FRAME > FRAME INFO
Firmware Version (FW Version)
Further internal version numbers are displayed on right side of screen; Bundle, DSP, FPGA and Safe Image version.
Serial Number (Serial No.)
The printed serial number on the back panel of the PLM+ is also electronically embedded in the hardware, and
therefore cannot be removed or altered if stolen.
Default Output Voltage (DefOutVolt)
Displays the default output voltage per channel that can exist across the PLM+'s output terminals. This is the
absolute maximum, only the voltage defined by the ISVPL setting. The voltage can go higher with RPM;
see the technical data sheet for actual maximum voltage.
Note: When Bridge Mode is activated, double the channel output voltage is available.
Max Output Current (MaxOutCurr)
Displays the maximum output current that can be delivered by the PLM+, summed across all output channels.
7.11.5.2. Frame Reset and Configuration
MENU > FRAME > RESET
Use this option to display a further menu with options to reset all parameters back to their original factory default
values. See section 9.3 for a full list of the default factory reset parameter values. Two types of reset are provided:
Factory Reset and Soft Reset.
Factory Reset
the deletion of any Frame Presets stored within the device. It also resets the IP Address and all network related
settings including the Dual Redundancy setting; a hard power cycle is required to complete this reset.
Soft Reset
56
PLM+ SERIES Operation Manual rev 3.0.1