Lab.gruppen PLM 20K44 Operation Manual page 43

Note: Output limiter (gain reduction) meters take into account the sum of PLM+ ISVPL and Lake
LimiterMax.
10
mode or Bridge Mode, as shown in Figure 7.8 For further information on Bridge Mode, please refer to section
8.1.1.
Figure 7.8: Standard and Bridge Mode Front Panel Icons (only for PLM 12K44 and PLM 20K44)
Bridge Mode is visible via this icon notation on the PLM+ Front Panel in Home View, however, the Lake Controller
information.
7.10.2. Amplifier Meters View
shown in Figure 7.9.
Output 1: V - Voltage Meter
1
Output 2: V - Voltage Meter
2
Output 3: V - Voltage Meter
3
Output 4: V - Voltage Meter
4
LoadPilot Status: 1. High Freq Pilot tone Enabled/Disabled, 2. Low Freq Pilot tone Enabled/Disabled, Status
5
I - Current Meter P - Power Meter
I - Current Meter P - Power Meter
I - Current Meter P - Power Meter
I - Current Meter P - Power Meter
l to which each module output is routed. When
L - Gain Reduction Meter
L - Gain Reduction Meter
L - Gain Reduction Meter
L - Gain Reduction Meter
PLM+ SERIES Operation Manual rev 3.0.1
7. Front Panel Interface
43