Lab.gruppen PLM 20K44 Operation Manual page 47

7.11.1.1. Parameters with Individual Values and Group Totals
The following parameters display two values:
• MODULE > GAIN
• MODULE > DELAY
• MODULE > LIMITERS > MAXRMS LEVEL
• MODULE > LIMITERS > MAXPEAK LEVEL
The Module parameter can be adjusted using the rotary encoder. The Group total (shown in brackets) is only
adjustable using the Groups function in the Lake Controller.
The Group total is the sum of the individual Module value plus any values for this parameter on all Groups to which
the Module is assigned. Please refer to the Lake Controller Operation Manual for further information on Groups.
7.11.1.2. Menu Structure Overview
From the Main Menu, the following submenus are available, as shown in Figure 7.13 and described in the following
sections.
• MODULE (See section 7.11.2)
• Input Mixer
• Gain
• Delay
• Polarity
• Amp Gain
• Limiters
• Mute
• INPUT/OUTPUT CONFIGURATION (See section 7.11.3)
• Input Router 1 - 4
• AES Termination
• Iso-Float
• Output Router
• ATTENUATION (See section 7.11.4)
• FRAME (See section 7.11.5)
• Frame Information
• Frame Reset
• BEL Configuration
• Network
• Latency Match
• Front Panel
• FRAME PRESETS (See section 7.11.7)
• Preset Recall
7. Front Panel Interface
PLM+ SERIES Operation Manual rev 3.0.1
47