Konica Minolta bizhub C754E Installation Manual page 25

XXXII. Network setting
Make the TCP/IP address setting for the network.
Note:
Consult the network administrator for the setting
value to be entered and make settings as
required.
1. Select the function to be used as follows:
Menu → Utility → Administrator Settings → Enter
the Administrator Password → Network Settings
→ TCP/IP Settings → IPv4 Settings.
2. Touch "Manual Input" of IP Address Setting
Method and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to
which the machine is connected
Default Gateway: IP address of the default gate-
way
3. Touch "OK" twice.
4. Select the function to be used as follows:
Forward → Detail Settings → PING Confirmation,
and make the operation check of TCP/IP.
Note:
After completing all the steps, take a sample
copy in color mode, and confirm the image. If
image troubles occur, first turn OFF and ON the
Main Power Switch, and then redo the steps
from E-11 "XII. Adjusting touch panel" to E-14
"XIX. List output."
XXXIII. Installing the user's guide holder/
spacer
1. Install the user's guide holder.
2. Install the supplied spacer.
XXXIV. Affixing the panel sheet
Affix the supplied panel sheet to the surface of the
operation panel.
Note:
• The panel sheet is affixed on customer request.
• The panel sheet must be kept by the customer.
E-25
A2X0IXC024DA
A2X0IXC022DA
A2X0IXC052DA