Unit Change; Adjusting The Height; List Output - Konica Minolta bizhub C754E Installation Manual

XVIII. Unit change
Note:
This function allows the user to select the type of
message that will appear when the replacement
time arrives for each of the different units.
1. Select the Unit Change function as follows:
System 2 → Unit Change.
2. Select the appropriate message type for each
unit.
3. Touch "END."
XIX. List output
1. Load the tray 1 with A4 or Letter paper.
2. Touch "List Output."
3. Check that "Machine Management List" is
selected and press the start key.
The list will be output.
4. Output "Adjustments List" in the same way.
5. Touch "2."
6. Check that "Service Parameter" is selected and
press the start key.
The list will be output.
7. Touch "END."
8. Touch "Exit" on the Service Mode screen.
9. Turn OFF and ON the Main Power Switch.
Note:
When displayed the Service Mode screen, be sure
to turn off the main power after exiting the Service
Mode screen and wait for 10 seconds or more
before turning on.
XX. Adjusting the height
1. Check the clearance between the upper face of
scanner and the protrusion on the reverse auto-
matic document feeder side (2 spots, front/back).
* There must be no clearance between the protru-
sion on the reverse automatic document feeder
and the upper face of scanner.
Note:
After checking the clearance, make the adjust-
ment described in step 2 if necessary.
OK
NG
2. Adjust the height by turning the adjustment screw
on the right side viewed from the back.
Clockwise: The rear side will move up.
Counterclockwise: The rear side will move down.
• If further adjustment is required, adjust the height
by using the adjustment screw on the left side
viewed from the back together.
Clockwise: The rear side will move up.
Counterclockwise: The rear side will move down.
E-14
Protrusion
A2X0IXC031DB
Protrusion
A2X0IXC032DB
A2X0IXC033DC