Konica Minolta bizhub C754E Installation Manual page 22

31. Press the start key, and check the difference in
the width A between the chart and the dis-
charged copy sample.
32. Touch "END" twice.
33. Touch "Exit" on the Service Mode screen.
34. Turn OFF and ON the Main Power Switch.
Note:
When displayed the Service Mode screen, be sure
to turn off the main power after exiting the Service
Mode screen and wait for 10 seconds or more
before turning on.
Note:
When the reverse automatic document feeder is
adjusted in Service Mode, "Adjustments list"
should be output again as necessary.
(Refer to E-14 "XIX. List output.")
XXVI. Changing paper size (Tray 3 and 4)
1. Turn OFF the Main Power Switch.
2. Pull out the tray 3.
3. Remove the front and rear paper guide plates.
(Four screws each)
Paper guide plate (rear)
Paper guide plate (front)
4. Remove the end guide plate. (Two screws)
E-22
<Inch area>
<Metric area>
A0P0IXC063DA
A2X0IXE070DA
A2X0IXC071DA