Anti-Rebound Bar - Britax BOULEVARD CLICKTIGHT Canadian User Manual

BRITAX Child Safety, Inc.
Forward-Facing
In forward-facing
installations, it is
important that the base
of the child seat rests
completely flat on the
vehicle seat. As seen
in the illustration, it is
permissible to allow up
to 7.6 cm (3 in.) of the
base to hang over the
edge of the vehicle seat.
Some vehicle seats do
not allow enough of the child seat base to contact the vehicle
seat. If this is the case, adjust the recline angle to a more
upright position. Not doing so could cause the child seat to
not perform as intended. Use the recline indicator on the child
seat to help achieve an acceptable recline angle, with the ball
in the recline indicator in the allowable green section.
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised
high enough to properly adjust the
harness for the fit of your child when
using a forward facing reclined
position. DO NOT force the child
seat head restraint past the vehicle
head restraint. Doing so could cause the child seat not to
perform as intended. If the location of the vehicle head
restraint interferes with the child seat head restraint, raise
or remove the vehicle head restraint. If the vehicle head
restraint cannot be removed, move the child seat to the
upright position or try a different seating location.
26
7.6 cm
7.6 cm
Acceptable Unacceptable
Overhang Overhang
BOULEVARD CLICKTIGHT Canadian User Guide

Anti-Rebound Bar

In the event of a crash, the anti-rebound bar is designed to
prevent rebound rotation in rear-facing car seat installations.
The anti-rebound bar is not intended for use as a carry
handle. Do not use the anti-rebound bar to carry this child
seat.
IMPORTANT: The anti-rebound bar MUST be removed for
forward-facing installation.
Installing the Anti-Rebound Bar
1. Pull back on the shell cover
behind the red marker and
locate the open end of the
structure tube.
2. Insert one end of the anti-
rebound bar into the tube,
then repeat for other side.
3. Lift up on tube to ensure
anti-rebound bar is
engaged.
NOTE: Closing the
CLICKTIGHT will completely secure
the anti-rebound bar.
Removing the Anti-Rebound Bar
1. Open the CLICKTIGHT.
2. Grasp the anti-rebound
bar at both sides and pull
away from the child seat.
27