Anti-Rebound Bar - Britax EMBLEM User Manual

BRITAX Child Safety, Inc.

Anti-Rebound Bar

In the event of a crash, the anti-rebound bar is designed to
prevent rebound rotation in rear-facing car seat installations.
The anti-rebound bar is not intended for use as a carry
handle. Do not use the anti-rebound bar to carry this
child seat.
IMPORTANT:
• The anti-rebound bar MUST be removed for forward-
facing installation.
• Keep fingers away from the anti-rebound bar connection
points to avoid finger entrapment or pinching.
Installing the Anti-Rebound Bar
1. With the car seat sitting
on a flat surface, pull the
recline handle, then rotate
the child seat shell into the
fully reclined position.
2. Place the car seat on
its back to access the
underside of the seat.
3. Locate the two ribs on
either side of the recline
handle.
4. Attach the two hooks of
the anti-rebound bar to
the metal rod between the
ribs on either side of the
recline handle, pressing
down until the hooks lock
into place.
IMPORTANT:
the anti-rebound bar to
ensure the connection is
secure.
NOTE: See Installation Videos & User Guides in the
support section of the Britax website (us.britax.com/faqs)
for a video demonstration of this procedure.
26
Pull up on