Maintenance; Cover - Britax BOULEVARD CLICKTIGHT Canadian User Manual

BRITAX Child Safety, Inc.

Maintenance

Cover

Removing the Cover
Never remove the buckle tongues from the harness.
They cannot be reattached after removal. If reassembled
incorrectly, the child seat may not perform as intended.
1. Loosen and unbuckle the
harness.
a. Push harness
adjuster button.
b. Pull both harness
straps forward.
c. Unbuckle the
harness.
2. Open the chest clip.
a. Press tabs.
b. Pull apart.
3. Remove the comfort
pillow and comfort pads if
necessary.
4. Remove the belly pad and
buckle.
a. Open the
CLICKTIGHT and
remove the two
elastic loops on
the bottom of the
CLICKTIGHT.
b. Lift the front of
the seat cover
and pull over the
CLICKTIGHT bezel
to access the buckle
strap connection.
c. Remove the harness
buckle by turning
the buckle strap
sideways and routing
the retainer out of
the front buckle slot
in the child seat (see
page 38).
34
1b
1a
b
2b
a
2a
4a
4b
4c
BOULEVARD CLICKTIGHT Canadian User Guide
d. Pull the end of the
belly pad and buckle
retainer out of the
buckle slot in the
cover to remove.
– Turn the buckle
retainer sideways
and slide the buckle
out of the belly pad
(see page 39).
e. Remove seat cover.
5. Detach the hook and loop
fasteners on the head
restraint from around the
harness.
6. Remove the head
restraint.
a. Raise the harness to
the highest position.
b. Detach the elastic
straps from the rear
of the head restraint.
7. Ensure the CLICKTIGHT
is open and remove the
lower shell cover.
a. Detach elastic loops
at front of shell.
b. Lift up from the front
to remove the lower
shell cover.
c. Pull cover up at
sides and around
rear-facing belt
paths.
8. Lower the harness, reach
around the head restraint,
and pull the upper shell
cover towards you to
remove.
4d
6b
7a
7b
35