Example Of Operation With 4 Smartkeys/Code Keypads; Disarming For "Forced Unlocking And Alarm Display - Bosch SE 320 LSNi Installation Manual

Operating the System

Example of Operation with 4 SmartKeys/Code Keypads

All SmartKeys/code keypads have equal arming and disarming rights.
1
Detection area
3

Disarming for "Forced Unlocking and Alarm Display"

!
The operator's attention must be drawn to the following points if this function has been
programmed in the EMA.
If the red LED on the reader flashes continuously after disarming, it means that the
SmartKey is signaling an intrusion alarm. It is recommendable to have a procedure in place for
this event to protect the operator, e.g.: do not enter the area, call the alarm company or the po-
lice, etc. The red LED will be deactivated when the intrusion detection system is reset.
If programmed, this function will immediately retract the SPE blocking element bolt when an ex-
ternal alarm is triggered; an optical signal (flashing red LED) will indicate this status when the ex-
ternal alarm is disarmed.
2
4
38
Arming:
Arming can occur with any SmartKey
once all the bolt contacts are closed
and the detection area is ready to acti-
vate. Arming will engage all SPE block-
ing element bolts.
Disarming:
Any SmartKey can be used for disarm-
ing. Disarming will disengage all SPE
blocking element bolts.