Arming In Stay Mode; Forced Arming; Disarming The System; Disarming With Code - Bosch AMAX panel 2000 User Manual

AMAX panel 2000 / AMAX panel 2000 EN
2.1.1.4 Key switch arming
Users can use a key switch to Arm and Disarm the system. When the Key switch is activated,
the AWAY indicator flashes slow and exit time starts. After exit time, the AWAY indicator is lit.
When the Key switch is deactivated, the system is disarmed and Away indicator is off.
2.1.2

Arming in STAY mode

STAY Mode is used when you need to arm the perimeter and unused areas of the premises to
detect a would-be intruder, while at the same time being able to move freely within an area
that is automatically isolated
There are two methods to arm your system in STAY Mode
To arm the system in STAY mode (method 1)
Enter your code and press [#].
Two beeps sound, the STAY indicator flashes slow and exit time starts. After exit time, the
STAY indicator is lit.
The lights corresponding to all zones programmed as automatically isolated zones (Interior
Instant Zone) begin to flash and continue until the exit time is finished.
To arm the system in STAY mode (method 2)
Press and hold [#] for 3 seconds.
When two beeps sound, release the button.
The STAY indicator flashes slow and exit time starts. After exit time, the STAY indicator is on.
Please contact your installer to enable/disable this function.
2.1.3

Forced arming

Arming the system when a zone is not sealed is known as forced arming. If the AWAY indicator
does not glow, and if a long beep sounds when you attempt to arm the system in AWAY Mode,
then forced arming is not permitted. If this is the case, then you will have to seal all zones or
manually isolate them before you can arm the system.
Please contact your installer to enable/disable this function.
2.2

Disarming the System

2.2.1

Disarming with CODE

Enter your code and press [#] .Two beeps sound and the AWAY or STAY indicator is
extinguished.
2.2.2

Disarming with wireless control Key

Press and hold the Disarming Button. Two beeps sound and the AWAY or STAY indicator is
extinguished.
2.2.3

Disarming with Key switch

When the Key switch is deactivated, the system is disarmed and the AWAY or STAY indicator is
extinguished.
Robert Bosch Engineering and Business Solutions Limited User Guide
Arming and Disarming the System | en
F.01U.249.500 | V2 | 2011.11
9