Mpls Quality Of Service Features Supported For Multilink Ppp - Cisco ASR 900 Series Manual

MPLS Multilink PPP Support
MPLS L3 VPN Feature
CSC VPNs with IPv4
label distribution
External and internal BGP
(eiBGP) Multipath
Internal BGP (iBGP)
Multipath
eBGP Multipath

MPLS Quality of Service Features Supported for Multilink PPP

The table below lists the Multiprotocol Label Switching (MPLS) quality of service (QoS) features supported
for Multilink PPP (MLP) and indicates if the feature is supported on customer edge-to-provider edge (CE-to-PE)
links, PE-to-provider (P) links, and Carrier Supporting Carrier (CSC) CE-to-PE links.
Table 3: MPLS QoS Features Supported for MLP
MPLS QoS Feature
Default copy of IP
Precedence to EXP bits
and the reverse
Set MPLS EXP bits using
the modular QoS
Command-Line Interface
(MQC)
Matching on MPLS EXP
using MQC
Low Latency Queueing
(LLQ)/Class-Based
Weighted Fair Queueing
(CBWFQ) support
Weighted Random Early
Detection (WRED) based
on EXP bits using MQC
Policer with EXP
bit-marking using MQC-3
action
MPLS Quality of Service Features Supported for Multilink PPP
CE-to-PE Links
Supported
Not supported
Not applicable to this
configuration
Not supported
CE-to-PE Links
Supported
Supported
Supported
Supported
Supported
Supported
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
PE-to-P Links CSC CE-to-PE Links
Not applicable to this Supported
configuration
Not supported Not applicable to this
configuration
Not supported Not applicable to this
configuration
Not supported Not supported
PE-to-P Links CSC CE-to-PE Links
Not supported Not supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
47