Mpls Basic Configuration Guide, Cisco Ios Xe Everest 16.5.1 (Cisco Asr 900 Series - Cisco ASR 900 Series Manual

Configuring the Pseudowire Class
Command or Action
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 pseudowire-class class-name
Example:
Device(config)# pseudowire-class mpls-tp-class1
Step 4
encapsulation mpls
Example:
Device(config-pw-class)# encapsulation mpls
Step 5 control-word
Example:
Device(config-pw-class)# control-word
Step 6
mpls label protocol [ldp | none]
Example:
Device(config-pw-class)# protocol none
Step 7 preferred-path {interface tunnel tunnel-number | peer
{ip-address | host-name}} [disable-fallback]
Example:
Device(config-pw-class)# preferred-path interface
tunnel-tp2
Step 8
status protocol notification static class-name
Example:
Device(config-pw-class)# status protocol notification
static oam-class1

MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)

24
Purpose
• Enter your password if prompted.
Enters global configuration mode.
Creates a pseudowire class and enters pseudowire
class configuration mode.
Specifies the encapsulation type.
Enables the use of the control word.
Specifies the type of protocol.
Specifies the tunnel to use as the preferred path.
Specifies the OAM class to use.
MPLS Transport Profile