MPLS Multilink PPP Support
Command or Action
Step 6
ppp multilink
Example:
Device(config-if)# ppp multilink
Step 7
mpls ip
Example:
Device(config-if)# mpls ip
Step 8
end
Example:
Device(config-if)# end
Assigning an Interface to a Multilink Bundle
SUMMARY STEPS
1. enable
2. configure terminal
3. controller {t1 | e1} slot/port
4. channel-group channel-number timeslots fulltimeslots
5. exit
6. interface serial slot/subslot / port : channel-group
7. ip route-cache [cef | distributed]
8. no ip address
9. keepalive [period [retries]]
10. encapsulation encapsulation-type
11. ppp multilink group group-number
12. ppp multilink
13. ppp authentication chap
14. end
DETAILED STEPS
Command or Action
Step 1
enable
Purpose
Enables MLP on an interface.
Enables label switching on the interface.
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
Assigning an Interface to a Multilink Bundle
53