Verifying the Multilink PPP Configuration
Command or Action
Step 13
ppp authentication chap
Example:
Device(config-if)# ppp
authentication chap
Step 14
end
Example:
Device(config-if)# end
Verifying the Multilink PPP Configuration
SUMMARY STEPS
1. enable
2. show ip interface brief
3. show ppp multilink
4. show ppp multilink interface interface-bundle
5. show interface type number
6. show mpls forwarding-table
7. exit
DETAILED STEPS
Step 1
enable
Enables privileged EXEC mode. Enter your password if prompted.
Example:
Device> enable
Device#
Step 2
show ip interface brief
Verifies logical and physical Multilink PPP (MLP) interfaces.
Example:
Device# show ip interface brief
Locolrface
GigabitEthernet1/0/0
MPLS Basic Configuration Guide, Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
56
Purpose
(Optional) Enables Challenge Handshake Authentication Protocol (CHAP)
authentication on the serial interface.
Returns to privileged EXEC mode.
IP-Address
OK? Method Status
10.3.62.106
YES NVRAM
MPLS Multilink PPP Support
Prot
up
up