...................................................................................................................................................................................................................................

Slot provisioning

Overview

The slot TS2 must be provisioned for a node in the process of creation.

Before you begin

Before provisioning slots, determine the following:

• Before provisioning the E slot configuration, it is assumed that the new

configuration of the E is known. This includes the exact types of units to be

provisioned and the corresponding slot positions for these units.

• For the 1645 AMC , the only slot which may be user assigned is TS2.

• The main unit must be assigned before its corresponding interface units are assigned.

Procedure

Proceed as follows to provision the slots of an E (this procedure includes both assigning

and unassigning units):

...................................................................................................................................................................................................

Select

Result:

...................................................................................................................................................................................................

Select the slot TS2 from the list in the window, and click

Result:

selected slot and its associated slots.

...................................................................................................................................................................................................

Select the desired operation from the selections at the top of the window.

Result:

...................................................................................................................................................................................................

If assigning units, use the pull-down menu for

corresponding to the displayed slot.

Result:

...................................................................................................................................................................................................

Click

Important! When assigning units during node creation, instead of the Provisioned E

Components window, the window ode Creation - Provision Slots will reappear.

6-20

Provisioning → Equipment → Provisioned NE Components

The Provisioned E Components window appears.

The Assign E Units to Slot window appears with information concerning the

The correct operation is selected.

The correct unit appears as the new Main Unit.

Proprietary – Use pursuant to Company instruction

Main Unit

Alcatel-Lucent – Internal