...................................................................................................................................................................................................................................

Coax connector (1.6/5.6)

Description

There are the following type of connectors:

• IMS — type 3320.52.1420.0D5 (45°)

• IMS — type 2630.52.1310.0D5 (Straight)

IMS

Important! Use of the correct tools to ensure a proper connection.

Proceed as follows to assemble a coax 1.6/5.6 connector:

...................................................................................................................................................................................................

Strip the cable according to the dimensions indicated in the next figure and tin the center

conductor.

Important! The stripping lengths depend on the used connector type.

...................................................................................................................................................................................................

Pull the crimp outer ferrule over the stripped cable.

...................................................................................................................................................................................................

Pull back the cable braid.

...................................................................................................................................................................................................

Push the center conductor and the dielectric into the connector housing until the dielectric

stops.

...................................................................................................................................................................................................

Solder the inner conductor to the center contact of the connector housing.

...................................................................................................................................................................................................

After soldering, press the cover into the connector body.

...................................................................................................................................................................................................

First roll the cable braid over the termination part (inner ferrule) of the connector and pull

the crimp outer ferrule over that braid.

...................................................................................................................................................................................................

Crimp the outer ferrule with a hexagon die 4.6 — AGK 3068 by using the Crimp Tool —

AGK 2365.

N D

O F

...................................................................................................................................................................................................

365-313-103R8.0

Issue 2 July 2009

S T E P S

Alcatel-Lucent – Internal

Proprietary – Use pursuant to Company instruction

Coax connector (1.6/5.6)

C-5

Table of Contents