Table of Contents
Advertisement
System cabling
...................................................................................................................................................................................................................................
ote: The routing of the ITM-CIT cable should be in accordance with the
recommended practices of the cable selected. The cable should be strain relieved to
prevent any force from being exerted on the connectors.
Orderable cable
An ITM-CIT cable with a length of 1.5 m [4.921 ft] can be ordered (CC848069795).
ote: A standard RS232 cable can also be used.
Figure 4-19 ITM-CIT cable connection
EOW interfaces
Purpose
An Engineering Order Wire (EOW) can be connected to these interfaces.
ote: The EOW interfaces are only available on 1645 AMC units.
Connector data
The 1 × E1/E2/F1 EOW connectors are 15-pin SUB-D male connectors (hot shrinked,
tailed). They provide V.11 data channels with a bit rate of 64 kbit/s.
Figure 4-20 EOW connector
1
9
Table 4-10
...................................................................................................................................................................................................................................
4-20
8
15
Pin assignment (EOW cables, valid for both connectors)
Point on connector
1
2
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Signal name
G D
V11RCP
External cable installation
ITM-CIT interface
365-313-103R8.0
Issue 2 July 2009
Advertisement
Chapters
Table of Contents
