Usb Driver Installation - FLIR X6570sc series User Manual

9
Interfaces
The USB connection requires a FLIR USB driver on the camera and also on the com-
puter. Depending on the camera, there are two scenarios:
1. The camera has a newer FLIR USB driver
When the FLIR ReseachIR Max software is installed on the computer, a valid FLIR
USB driver is automatically installed on the computer. When this FLIR USB driver is
installed, FLIR Camera Network Device is listed under Network adaptors in Windows
Device Manager. No manual installation of a USB driver is required, but you need to
configure the network interface (see section 9.2.3 Configuration of the network inter-
face, page 51).
2. The camera has a legacy FLIR USB driver
Installation of the driver FLIR X8400sc - X6500sc – USB.inf is required on the com-
puter. For more information, see section 9.2.2 USB driver installation, page 47. After
installing the driver, you need to configure the network interface (see section 9.2.3
Configuration of the network interface, page 51).
Note
• The connection type to the camera is RDNIS over a USB connection.
• The following operating systems are supported:
◦ Microsoft Windows 7 32 and 64 bit
◦ Microsoft Windows Vista 32 and 64 bit
◦ Microsoft Windows XP SP2

9.2.2 USB driver installation

This section applies to cameras with the legacy FLIR USB driver. Installation of the driver
FLIR X8400sc - X6500sc – USB.inf is required on the computer. Contact your FLIR serv-
ice centre or visit http://support.flir.com to download the driver.
9.2.2.1 First time installation
9.2.2.1.1 General
When the camera is connected to the computer by a USB cable for the first time, Win-
dows detects the camera and prompts you to select the driver.
9.2.2.1.2 Procedure
Follow the procedure below to install the USB driver:
1. Connect the camera to the computer using the USB cable.
2. At the Windows prompt, select the FLIR X8400sc - X6500sc – USB.inf file.
#T810204; r. AA/43079/43091; en-US
47