Siemens SIMATIC ET 200SP Manual page 12

Product overview
2.1 Properties
Properties
The module has the following technical characteristics:
● Fail-safe digital module
● PROFIsafe
● Supports the "RIOforFA-Safety" profile on F-CPUs S7-1200/1500.
● PROFIsafe address type 2
● 8 outputs, PP-switching (SIL3/Cat.4/PLe)
● Supply voltage L+
● Output current 0.5 A per output
● Sourcing output (PP-switching)
● Suitable for solenoid valves, DC contactors and signal lamps
● Direct interconnection to inputs of an F-DI possible
● Diagnostics display (DIAG red/green LED)
● Status display for each output (green LED)
● Fault display for each output (red LED)
● Diagnostics
– e.g., short-circuit, channel-specific
– e.g. supply voltage missing, module-specific
● module-wide passivation
The module supports the following functions:
● Firmware update
● I&M identification data
The fail-safe performance characteristics in the technical specifications apply for a mission
time of 20 years and a repair time of 100 hours. If a repair within 100 hours is not possible,
remove the respective module from the BaseUnit or switch off its supply voltage before 100
hours expires. The module switches off independently after the 100 hours have expired.
Follow the repair procedure described in section Diagnostics alarms (Page 42).
Note
Cyclic reading of I&M data
Cyclic reading of I&M data can affect the timing of the F-modules. You should therefore
avoid short read cycles of less than 500 ms.
12
WARNING
Digital output module F-DQ 8x24VDC/0.5A PP HF (6ES7136-6DC00-0CA0)
Manual, 05/2017, A5E38578424-AA