SET0403030
4.3.3 Installing option (New SB)
Install according to the following procedures.
ANNT)
- The installation location and quantity have to indicate by the system administrator.
- Confirm connecting position of power cable of the Base Unit beforehand.
(1) Prepare the new SB.
(2) Follow the instructions of the system administrator to install memories.
See Appendix F.8 "Memory".
(3) Next procedure follows to chapter 2
SET0404000
4.4 Verifying operation
Confirm the installed memory according to the following procedures.
(1) Start Video Redirection.
See Appendix E.3.1
(2) Set "BIOS Setup" at "Boot Device Selector".
See Appendix E.4
(3) Turn on the system power.
See Appendix E.5.1
→ Wait for a few minutes until "Figure 4.4-1" is displayed. (Max. 10 minutes)
"Installing System
"Video Redirection
start".
"Boot Device Selector
setting".
"Power
On".
Board".
34