Mounting The Adding Options (New Sb) - Cisco C880 M4 Service Manual
Hide thumbs
Also See for C880 M4:
- Configuration manual (146 pages) ,
- Operating manual (58 pages) ,
- Service supplement manual (27 pages)
Table of Contents
Advertisement
(3) Enter Maintenance Mode.
See Appendix B.1.1, "Enabling maintenance Mode (APP0201010)".
(4) Confirm that requirements for mounting the added options satisfy ones listed on table 3.2.2-2.
If requirements are not satisfied, check with the system administrator to satisfy the requirements.
Section
1
(5) Prepare the system board (SB) to which the DIMMs will be added.
See Appendix C.2, "System Board (APP0302000)".
(6) Mount the DIMMs.
See "3.1.3 Memory mounting order (SET0301030)", See Appendix C.4, "Memory (APP0304000)".
(7) Install the system board (SB) in the main unit.
See Appendix C.2, "System Board (APP0302000)".
(8) Wait about 1 minute and confirm that the Alarm LED of the system board is off.
(9) Change Maintenance Mode disabled. See Appendix B.1.2," Disabling maintenance mode
(APP0201020)".
SET0302030
3.2.3 Mounting the adding options (New SB)
Use the following steps to mount the added options.
ANNT)Confirm the quantities and installation locations with a system administrator.
(1) Confirm that requirements for mounting the added options satisfy ones listed on table 3.2.3. If
requirements are not satisfied, check with the system administrator to satisfy the requirements.
Section
1
(2) Prepare the new system board (SB) to which the DIMMs will be added.
See Appendix C.2, "System Board (APP0302000)".
(3) Confirm the numbers and mounting locations of the options.
(4) Mount the DIMMs.
See "3.1.3 Memory mounting order (SET0301030)", See Appendix C.4, "Memory (APP0304000)".
(5) See Chapter 1 Adding a System Board
Items to be confirmed
If mounting DIMMs and adding a new SB should be done,
confirm that requirements on 3.1.2 Conditions on mixing different types of
DIMMs
(SET0301020)
Items to be confirmed
If mounting DIMMs and adding a new SB should be done,
confirm that requirements on 3.1.2 Conditions on mixing different
types of DIMMs
(SET0301020)
(SET0100000)
Table 3.2.2-2
are satisfied.
Table 3.2.3
are satisfied.
for the next instructions.
28
CA92344-0577-01
Advertisement
Table of Contents
