Table of Contents
Advertisement
Example of the labels affixed to the array disks that are the first and second ones from the left at the
bottom of a rack
2) According to the installation drawing (cable connection diagram), write down the destinations on
the cable destination labels to be attached to both ends of the cables to be connected.
Cable destination label with ties 25 mm in diameter, 120 mm long.
Format of written destination
Format: Xy-ZZZ => (CCC)
Xy: See item 1) above.
ZZZ: Physical location of the connection destination of the connector at this end of the cable (Use the
physical location name referring to the unit concerned.)
CCC: Destination of the connector at the other end of the cable (same format as above)
Example of written labels indicating a connection between port 2 of the PT board in slot 4 of the main
unit (first from the left) and channel 12 of the hub (third from the left)
3) Attach the cable destination labels with ties to both ends of each cable. (Wrap the string at least
twice around the cable or affix cotton tape on the string to prevent the string from moving.)
Make sure that the cable destinations on the two labels attached to each cable are reversed as shown
t
in
he following figure.
Figure I-3 Cable destination label with tie
168
Advertisement
Table of Contents
