Connecting Power Supply - Christie LW751i Setup Manual

Connecting power supply

Put the connector of the power
1.
cord into the AC (AC inlet) of
the projector.
Push the cord stopper until it is caught by
2.
the hook.
Firmly plug the power cord's plug into the
3.
outlet. In a couple of seconds after the power
supply connection, the POWER indicator
lights up in steady orange.
When the DIRECT POWER ON function activated, the connection of the power
supply make the projector turn on.
WARNING ►Do not connect the projector to a power supply while no lens
unit is attached to it.
►Use extra caution when connecting the power cord, as incorrect or faulty
connections may result in fire and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fire, electric
shock or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE ►This projector is also designed for IT power systems with a phase-
to-phase voltage of 220 to 240 V.
http://www.pureglare.com.au
LWU701i/LW751i/LX801i/LWU601i/LW651i
Setup Guide
AC
Power
cord
Cord
stopper
12
Power
Cord
Hook
020-000792-02
LIT GUID SET D2