Leica Autostainer XL Instructions For Use Manual page 8

1
Important Information
Symbols:
Symbol:
Symbol:
Symbol:
Symbol:
Symbol:
Symbol:
Symbol:
8
Title of the symbol:
Description:
Title of the symbol:
Description:
Title of the symbol:
Description:
Title of the symbol:
Description:
Title of the symbol:
Description:
Title of the symbol:
Description:
Title of the symbol:
Description:
Title of the symbol:
Description:
Caution – Toxic chemicals / Flamable substances
Labels are attached inside the instrument below the
fixation of the hood (in the middle).
The first label indicates that toxic chemicals are inside
the instrument. Do not handle solution containers un-
less properly protected.
The second label indicates that there is a risk of fire
because of flamable substances inside the instrument.
Thus, avoid any source of ignition close to the instru-
ment.
Caution – Hot surface
Two labels are attached close to the oven. They
indicate a risk of burns because of hot surfaces. Do
not touch these parts.
Caution – Risk of fire
Label is attached at the rear of the instrument close
to the fuse. It indicates a risk of fire in case that no or
inappropriate fuses are used. For continued protection
against the risk of fire replace only with appropriate
fuses as indicated on the instrument.
Caution – Input voltage
Label is attached at the rear of the instrument above
the switched mains power inlet. It indicates that the
unit is wired either for 100-120 VAC or 230-240 VAC
(depending on your order). Do not change wiring or
voltage selection on your own but contact qualified
Leica service personnel in this case.
Caution – Water supply and interfaces
Labels are attached at the rear of the instrument close
to the serial port and the water supply connections.
They indicate that both Instructions for Use and – if
applicable – any inscription on the instrument must
be observed.
CSA Statement (Canada/USA)
The CSA test mark means that a product has been
tested and fulfills the applicable safety standards.
Serial number
Indicates the manufacturer's serial number so that a
specific medical device can be identified.
Article number
Indicates the manufacturer's catalog number so that
the medical device can be identified.
Version 3.0, Revision I