Table of Contents
Advertisement
A
A
I
Changing a wheel
P40.10-6481--31
Steel wheel with hub cap
Vehicles with steel wheels and hub caps:
remove the hub cap.
P40.10-6523-3 1
wheel wrench
G),
loosen the bolts
on the wheel you wish to change by about
one full turn. Do not unscrew the bolts
completely.
P40. 10-6524-3 1
The vehicle may only be raised at the des-
ignated jacking points on the sill.
The jacking points are located just behind
the front wheel arches and just in front of
the rear wheel arches (arrows). You can
identify the jacking points by the trian-
gular indentations on the sill.
To avoid damage, position the jack cen-
trally under the triangular indentations.
P40.10-6482--31
Position jack ® centrally under the tri-
angular indentations at jacking points
on the sill
G) .
P40.0Q-2254-31
Example
sure that the base of the jack is
positioned vertically under the jacking
point.
the vehicle with jack ® until the
tyre is at most 3 cm off the ground.
Removing a wheel
U
Do not place wheel bolts in sand or dirt.
The threads of the wheel bolts and wheel
hubs could otherwise be damaged when
the bolts are tightened.
Unscrew the wheel bolts.
Remove the wheel.
Advertisement
Table of Contents
