Table of Contents
Advertisement
When tow-starting, it is important that you
observe the safety instructions
(I>
page 212)
and the legal requirements in each respec-
tive country.
on the hazard warning lamps
(I>
page 86) .
the towing eye
(I>
page 213) .
Secure t he rigid towing bar or the towing
rope.
Depress and hold the brake pedal.
the key to position 2 in the igniti on
lock.
Depress the clutch pedal fully, engage
second gear and keep the clutch pedal
fully depressed.
Release the brake pedal.
the vehicle .
Release t he clutch pedal slowly; do not
depress the accelerator pedal while
doing so.
When t he engine is started, immediately
depress the clutch pedal fully and select
neutral.
Pull over at a suitabl e place and stop the
vehicle safely, paying attention to road
and traffic conditions .
Secure the vehicle against rolling away
with the parking brake.
the rigid towing bar or towing
rope.
the towing eye
(I>
page 214).
off the hazard warning lamps.
Electrical fuses
Important safety notes
&_
WARNING
If you manipul ate, bridge or replace a
faulty fuse wi th a fuse of a higher amper-
age, the electric cables could be overloa-
ded. This may result in a fire. There is a
risk of an accident and injury.
Electrical fuses
Always repl ace faulty fuses wi th specified
new fuses of the correct amperage.
D
Only use fuses that have been approved
for smart vehicles and which have the
correct fuse rating for the system con-
cerned. Components or systems could
otherwise be damaged.
The fuses in your vehicle serve t o discon-
nect faulty circuits.
If
a fuse blows, all the
components on the circuit and their func-
tions will fail.
Blown fuses must be replaced with fuses of
the same rating, which you can recognise by
the colour and fuse r ating . The fuse ratings
are listed in the fuse allocation chart
(I>
page 217).
If the newly inserted fuse also blows, have
t he cause traced and rectified at a quali-
fied specialist workshop, e.g. a Mercedes-
Benz Service Centre.
Before replacing a fuse
Secure the vehicle against rolling away
(I>
page 120).
Switch off all electrical consumers.
Turn the key to position
0
in the ignition
lock and remove it
(I>
page
ill).
All indi -
cator lamps in the instrument cluster
must be off.
The fuses are located in various fuse boxes:
• Fuse box in the front area
• Fuse box in the glove compartment
Fuse box in the front area
Pay attention to the "Important safety
notes"
(I>
page 215).
&_
WARNING
If
the windscreen wipers start to move when
the service cover is open, you could become
caught up in the wiper rods. There is a risk
of injury.
I> I>
I
Advertisement
Table of Contents
