Table of Contents
Advertisement
corresponding to the direction of rota-
tion.
An arrow on the sidewall of the tyre indi-
cates its correct direction of rotation .
If
you fit M+S tyres that have a lower max-
imum permissible speed than that of the
vehicle, affix an appropriate warning sign
in the driver's field of vision. This can be
obtained at a qualified specialist work-
shop.
Under these circumstances, you should also
use the speed limiter to restrict the max-
imum speed of the vehicle so that i t does
not exceed the maximum permissible speed
for the M+S tyres
(I>
page 128).
When you have fitted the M+S tyres:
.,.. Check the tyre pressures
(I>
page 225).
.,.. Restart the tyre pressure monitor (vehi-
cles with black and white display)
(I>
page 228).
.,.. Restart the tyre pressure monitor (vehi-
cles with colour display)
(I>
page 228).
Snow chains
&
WARNING
If
you have fitted snow chains to the front
wheels, they may scrape against the vehicle
body or chassis components. This could
cause damage to the vehicle or the tyres.
There is a risk of an accident.
To avoid hazardous situations:
• never fit snow chains on the front wheels
• fit snow chains to the rear wheels in
pairs.
U
Vehicles with st eel wheels: if you fit
snow chains on steel wheels, you may
damage the hub caps. Remove the hub caps
from the relevant wheels before fitting
the snow chains.
smart recommends that you only use snow
chains that have been specially appr oved
for smart. For more information, please
Tyre pressure
contact the smart centre or a qualified
specialist workshop.
If
you intend to fit snow chains, please bear
the following points in mind:
• snow chains cannot be fitted to all
wheel- tyre combinations. Permissible
wheel-tyre combinations
(I>
page 234) .
• only use snow chains when the road sur-
face is completely snow- covered. Remove
the snow chains as soon as possible when
you come to a road that is not snow-cov-
ered.
• local regulations may restrict the use of
snow chains. Observe the appropriate
regulations
if
you wish to fit snow
chains.
• do not exceed the maximum permissible
speed of 50 km/h .
Tyre pressure
Tyre pressure specifications
&
WARNING
Underinflated or overinflated tyres pose
the following risks:
• the tyres may burst, especially as the
load and vehicle speed increase.
• the tyres may wear excessively and/or
unevenly, which may greatly impair tyre
traction.
• the driving characteristics, as well as
steering and braking, may be greatly
impaired.
There is a risk of an accident.
Observe the recommended tyre pressure and
check the tyre pressure of all the tyres:
• at least every two weeks
• when the load changes
• before embarking on a longer journey
• for changed operating conditions, e.g.
off-road driving
If necessary, correct the tyre pressure.
A
A
I
Advertisement
Table of Contents
