Electrical Fuses - SMART Fortwo 2015 Owner's Manual

The towing eye can be used to pull the vehicle
onto a trailer or transporter for transporting
purposes.
Tow-starting (emergency engine start-
ing)
i
You can find information on "Jump-start-
Y
ing" at ( page 190).
Before tow-starting the following conditions
must be fulfilled:
the battery is connected.
R
the engine has cooled down.
R
the exhaust system has cooled down.
R
When tow-starting, it is important that you
observe the safety instructions (
and the legal requirements in each respec-
tive country.
X
Switch on the hazard warning lamps
Y
( page 75).
X
Fit the towing eye (
X
Secure the rigid towing bar or the towing
rope.
X
Depress and hold the brake pedal.
X
Turn the key to position 2 in the ignition
lock.
X
Vehicles with automatic transmission:
activate the manual gearshift setting
Y
( page 102).
X
Vehicles with manual transmission:
depress the clutch pedal fully, engage sec-
ond gear and keep the clutch pedal fully
depressed.
X
Release the brake pedal.
X
Tow-start the vehicle.
X
Vehicles with automatic transmission:
push the selector lever forwards towards
q until the engine starts. Do not depress
the accelerator pedal while doing so.
X
Vehicles with manual transmission: with-
out depressing the accelerator pedal,
release the clutch pedal slowly.
X
Vehicles with manual transmission: when
the engine is started, immediately depress
the clutch pedal fully and select neutral.
X
Pull over at a suitable place and stop the
vehicle safely, paying attention to road
and traffic conditions.
Y
page 192)
Y
page 193).
X
Secure the vehicle against rolling away
with the parking brake.
X
Remove the rigid towing bar or towing
rope.
X
Remove the towing eye (
X
Switch off the hazard warning lamps.

Electrical fuses

Important safety notes
G
WARNING
If you manipulate, bridge or replace a
faulty fuse with a fuse of a higher amper-
age, the electric cables could be overloa-
ded. This may result in a fire. There is a
risk of an accident and injury.
Always replace faulty fuses with specified
new fuses of the correct amperage.
!
Only use fuses that have been approved for
smart vehicles and which have the correct
fuse rating for the system concerned. Com-
ponents or systems could otherwise be dam-
aged.
The fuses in your vehicle serve to disconnect
faulty circuits. If a fuse blows, all the com-
ponents on the circuit and their functions
will fail.
Blown fuses must be replaced with fuses of the
same rating, which you can recognise by the
colour and fuse rating. The fuse ratings are
listed in the fuse allocation chart
Y
( page 197).
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified
specialist workshop, e.g. a Mercedes-Benz
Service Centre.
Before replacing a fuse
X
Secure the vehicle against rolling away
Y
( page 107).
X
Switch off all electrical consumers.
X
Turn the key to position 0 in the ignition
lock and remove it (
tor lamps in the instrument cluster must be
off.
Electrical fuses
Y
page 193).
Y
page 93). All indica-
Z
195