Table of Contents
Advertisement
6.2.3
The window should look like this:
Select all the checkboxes under the Program/Configure for CFM0 and UFM (highlighted in red
above).
6.2.4
Click "Start" to configure MAX10. The programming could take a while.
6.2.5
When the programming is finished, the MAX1000 should be able to keep its configuration
data even after powered off.
6.3 Testing the Design
Does not matter which way the MAX1000 was configured, the results should be the same for both
methods, with the only difference being if configuration is retained after power off.
On the board by default, the LEDS should now toggle in a slow counting sequence.
Push and hold the USER_BTN to see that the LEDs will now toggle in a very fast counting sequence.
USER_BTN is on the side of the LEDs.
Releasing the USER_BTN, will make the LEDs toggle at a slower rate as before.
MAX1000 User Guide
Page | 70
www.arrow.com
July 2017
Advertisement
Table of Contents
