Wiznet WIZ630wi User Manual page 42

Hide thumbs Also See for WIZ630wi:
Table of Contents

Advertisement

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an Outlet on a circuit different from that to which the
receiver is connected.
To OEM Installer
1. FCC ID on the final system must be labeled with "Contains FCC ID: XR2WIZ630WI" and
"Contains transmitter Module FCC ID: XR2WIZ630WI "
2. In the user manual, final system integrator must ensure that there is no instruction
provided in the user Manual to install or remove the transmitter module.
3. Transmitter module must be installed used in strict accordance with the
Manufacturer's instructions as described in the user documentation that comes with the
product.The user manual of the final host system must contain the following statements:
This device complies with Part 15 of the FCC rules. Operation is subject to following
Two conditions: 1. this device may not cause harmful interference and 2. This device
Must accept any interference received including interference that may cause undesired
operation of this device.
The changes or modifications not expressly approved by the party responsible for
Compliance could void the user's authority to operate the equipment.
To comply with the FCC RF exposure compliance requirements, this device and its antenna
must not Be co-located or operating to conjunction with any other antenna or transmitter,
except if installed In compliance with FCC Multi Transmitter procedures.
To inherit the modular approval, the antennas for this transmitter must be installed to
provide a Separation distance of at least 20cm from all persons and must not be co-located
or operating in Conjunction with any other antenna or transmitter.
Note:
The buyer of the module who will incorporate this module into his host must submit the
final product to the Manufacturer of the module and the MANUFACTURER OF THE MODULE
WILL VERIFY that the product Is incorporated in host equipment in a way that is represented
by the testing as shown in the test report.
Note:
The module is used AP, Gateway, Household. (except PC.)
42
© Copyright 2012 WIZnet Co., Inc. All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents